/*
ESP32SoftwareSerial.h

ESP32SoftwareSerial.cpp - Implementation of the Arduino software serial for ESP8266.
Copyright (c) 2015-2016 Peter Lerup. All rights reserved.

This library is free software; you can redistribute it and/or
modify it under the terms of the GNU Lesser General Public
License as published by the Free Software Foundation; either
version 2.1 of the License, or (at your option) any later version.

This library is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the GNU
Lesser General Public License for more details.

You should have received a copy of the GNU Lesser General Public
License along with this library; if not, write to the Free Software
Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA  02110-1301  USA

*/

#ifndef ESP32SoftwareSerial_h
#define ESP32SoftwareSerial_h

#include <inttypes.h>
#include <Stream.h>

#define DEFAULT_BUAD_RATE 9600

// This class is compatible with the corresponding AVR one,
// the constructor however has an optional rx buffer size.
// Speed up to 115200 can be used.

class ESP32SoftwareSerial : public Stream
{
  public:
    ESP32SoftwareSerial(int receivePin, int transmitPin, bool inverse_logic = false, unsigned int buffSize = 64);
    ~ESP32SoftwareSerial();

    void begin(uint32_t speed);
    long baudRate();
    void setTransmitEnablePin(int transmitEnablePin);

    bool overflow();
    int peek();

    virtual size_t write(uint8_t byte);
    virtual int read();
    virtual int available();
    virtual void flush();
    operator bool() { return m_rxValid || m_txValid; }

    // Disable or enable interrupts on the rx pin
    void enableRx(bool on);

    void rxRead();

    // AVR compatibility methods
    bool listen()
    {
        enableRx(true);
        return true;
    }
    void end() { stopListening(); }
    bool isListening() { return m_rxEnabled; }
    bool stopListening()
    {
        enableRx(false);
        return true;
    }

    using Print::write;

  private:
    bool isValidGPIOpin(uint8_t pin);

    // Member variables
    int m_rxPin, m_txPin, m_txEnablePin;
    bool m_rxValid, m_rxEnabled;
    bool m_txValid, m_txEnabled;
    bool m_invert, m_overflow;
    uint32_t m_bitTime, rx_bit_time;
    volatile uint32_t m_inPos, m_outPos;
    int m_buffSize;
    uint8_t *m_buffer;
    // void WAIT(uint32_t &start, uint32_t &wait);
};

// If only one tx or rx wanted then use this as parameter for the unused pin
#define SW_SERIAL_UNUSED_PIN -1

#endif